Worcester 28CDI Instrukcje Operacyjne Pobierz pdf (Strona 39)

GENERAL

INFORMATION

GAS SAFETY (INSTALLATION AND USE)

REGULATIONS 1998

It is the law that all gas appliances must be installed by a competent

person in accordance with the above regulations. Failure to install

appliances correctly could lead to prosecution. It is in your interest and

that of safety to ensure compliance with the law. The manufacturers

notes must not be taken, in any way, as overriding statutory obligations.

WARNING: This appliance must be earthed and protected by a 3

amp fuse.

ELECTRICITY SUPPLY: 230V ~ 50Hz

IMPORTANT: To get the best from your Worcester CDi please read

these instructions carefully.

NOTE: In the event of a fault the appliance should not be used

until the fault has been corrected by a competent person.

BENCHMARK

The Benchmark initiative is a code of practice to encourage the

correct installation, commissioning and servicing of domestic central

heating boilers and system equipment.

A 'log book' is dispatched with every appliance, This is a vital

document that needs to be completed by the installer at the time of

installation. It confirms that the boiler has been installed and

commissioned according to the manufacturers instructions.

All CORGI Registered Installers carry a CORGI ID card and have a

registration number. Both should be recorded in your central heating log

book. You can check that your installer is CORGI registered by calling

CORGI on 01256 372300.

Without the completion of the log book, manufacturers may

refuse to respond to a call-out request. It is important that your installer

has given you the fully completed log book.

GENERAL DESCRIPTION

(See Fig.1.)

The WORCESTER CDi MODELS are combined domestic hot water

and central heating appliances. They consist of a gas fired boiler having

a varying output of between:

CH DHW

24CDi 9.0 - 24kW 9.0 - 24kW

28CDi 9.0 - 24kW 9.0 - 28kW

35CDi

II 10.5 - 27.5kW 9.5 - 35.3kW

a heat exchanger to provide domestic hot water via the boiler,

circulating pump and water diverting valve. All the necessary controls to

provide mains fed domestic hot water and central heating.

The appliances are supplied as standard with a manual operating

switch. Alternatively a facia mounted programmer may have been fitted.

The appliances can operate in one of two modes. Hot water only or

hot water and central heating.

Hot Water Mode:

When a demand is made for hot water by opening a tap or shower;

the flow switch will energise the pump and circulate primary hot water

around the boiler and water to water heat exchanger. The burner will

light to its maximum setting.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 45 46

Komentarze do niniejszej Instrukcji

Brak uwag

Worcester 28CDI Instrukcje Operacyjne Strona 39

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Termostaty Worcester 28CDI